Q: Why is the blade in the front of the
HeadBlade® and why do I push instead of pull it? Should I apply pressure?
A: After extensive development it was
found that the automatically pivoting blade of the HeadBlade® had to be in
front. Pulling the blade across your head creates lateral movement of the blade
which results in nicks and cuts. Pushing the blade eliminates lateral movement.
And no, you don't need to press down on the razor (no press down big boy). The
only pressure you need to put is on back pad to make sure it stays in contact
with your scalp.
Q: My fingers go up and down in size
(mostly in girth) depending on the weather. Is the HeadBlade® adjustable?
A: Yes. The HeadBlade® is made out of
a high quality plastic (it contains a lot of rubber) and the ring can be
adjusted to just about any finger size. To adjust your HeadBlade® warm the ring
with a hair dryer (not your own of course) and then gently manipulate the ring
to the appropriate size.
Q: How long will it take to rid myself
of the bad habits accumulated over years of shaving with a conventional razor to
fully appreciate this new method?
A: The HeadBlade® fits right inside the
palm of your hand and you may get the hang of it right off. But be patient, it
may take you three to five shaves before you become fully comfortable with the HeadBlade® and its revolutionary method (if you didn't pass 4th grade you may
experience a longer learning curve). Once you do get the feel of the HeadBlade®
you'll see your shaving time cut dramatically. And you'll get a better shave.
Note: The HeadBlade® should last a
year with regular use. However, after eight to nine months you should consider
purchasing a new
one. The adaptors will last about six months depending upon use.
a registered trademark of the HeadBlade® Company, LLC.
(The Gillette® Sensor™ and Atra™ are registered trademarks of The Gillette Company.)
Em's Place, Inc. is not affiliated with HeadBlade® or The Gillette Company.